Browsing by Author "Lakmal, A.A.I."

Now showing 1 - 2 of 2

Effect of CdTe nucleation layer on the performance of CdS/CdTe thin film solar cells
(J Mater Sci, 2023) Gajanayake, G.K.U.P.; Lakmal, A.A.I.; De Silva, D.S.M.; Dassanayake, B. S.
In this study, an electrodeposited CdTe nucleation layer (ED-CdTe*) was introduced on a chemical bath deposited (CBD) CdS layer prior to close-spaced sublimation (CSS) of the CdTe absorber layer to improve the efficiency of the CdS/CdTe solar cell by reducing the recombination mechanism in the depletion region. The ED-CdTe* nucleation layer grown in 40 s produced the highest efficiency of 9.12% with an open-circuit voltage (VOC) of 640 mV, while the CBD-CdS/CSS-CdTe solar cell delivered 8.07% efficiency, with a VOC of 596 mV. The ideality factor and the reverse saturate current density of the CBD-CdS/ED-CdTe*/CSS-CdTe solar cell were 2.28 and 6.65 × 10–5 mA/cm2, respectively. After being treated with CdCl2, the efficiency of the device with the nucleation layer (40 s) was elevated to 15.6% with a VOC of 761 mV, and that of the device with no nucleation layer was raised up to 14.6% with a VOC of 737 mV. Further, the solar cell with optimal ED-CdTe* nucleation layer showed the highest spectral response within the 400–900 nm wavelength range. The SEM and AFM analysis verified the formation of an ultrathin ED-CdTe* nucleation layer that can catalyse the film formation of CdTe by the CSS method while reducing the interface incongruity between CdS and CdTe layers.
Effect of film thickness on characteristic properties of thermally evaporated cadmium sulphide thin films
(Faculty of Science, University of Kelaniya, Sri Lanka, 2020) Lakmal, A.A.I.; Kumarasinghe, R.K.K.G.R.G.; Seneviratne, V.A.; Dassanayake, B.S.
Cadmium sulphide (CdS) thin films are regarded as one of the most promising materials for heterojunction solar cells. Due to its wide bandgap (~ 2.42 eV), CdS thin films have been used as the window material together with several semiconductors such as InP, CdTe, Cu2S, and CuInSe2. For the future development of photonic devices based on above materials comprehensive studies on CdS window layer throughout all aspects such as deposition technique, temperature, duration, and post-heat treatments, etc. are highly required. In this study, CdS thin films were deposited on the cleaned FTO glass substrates using vacuum thermal evaporation technique by varying the deposition duration to have different layer thicknesses. The temperature of the substrates and the chamber pressure were maintained at 175 °C and 2×10-5 torr respectively. The deposition was carried out using CdS powder (Sigma-Aldrich, 99.995%) containing in an alumina boat. Deposited samples were then annealed in vacuum (pressure 3×10-5 torr) at 300 °C for 30 minutes. The bandgap and optical transmittance of the deposited thin films were studied using UV-Visible spectrophotometry. The surface topology analysis of the deposited thin films was carried out using Atomic Force Microscopy (AFM). A photoelectrochemical cell of (CdS/0.1 mol L-1 Na2S2O3/Pt) was used to investigate electrical properties such as short circuit current (JSC), open circuit voltage (VOC), carrier concentration, and majority carrier type of the semiconductor with the aid of I-V measurements and Mott–Schottky measurements. The structural and crystal properties such as preferred orientation, phase distribution, crystallite size, microstrain, and lattice parameters were studied by employing the grazing incident X-ray diffraction. The calculations were done using the profile fit, Rietveld refinement, and Pawley refinement techniques. All the results revealed that there exists a correlation between the film thickness and the above-considered properties of the CdS thin film. The highest bandgap of 2.43 eV and optimum JSC and VOC of 113 µA/cm3 and 341 mV respectively were observed for the photoelectrochemical cell made by 210 nm thick CdS thin film.