Browsing by Author "Perera, R. T."

Now showing 1 - 2 of 2

Evaluation of toxic metal contamination in surface sediments and water in Mahakanadarawa tank; Anuradhapura, Sri Lanka
(Faculty of Science, University of Kelaniya Sri Lanka, 2022) Sampath, M.; Perera, R. T.; Perera, R. A.; Liyanage, J. A.; Premaratne, W. A. P. J.
Toxic elements, including heavy metals/metalloids, readily contaminate water reservoirs via natural mechanisms such as surface runoff, precipitation, and atmospheric deposition. As a result, some toxic metals can be accumulated in surface sediments in the reservoirs and be incorporated into the food chains. It has become a major issue because various trace elements contaminate water, soil, and sediments, which can have serious health consequences due to their toxicity, persistence, and carcinogenic nature. This study was carried out with the aim of analysing the sediment quality in a major irrigation tank called Mahakanadarawa tank in Anuradhapura district, which is located in a high prevalence of chronic kidney disease of unknown etiology (CKDu) in Sri Lanka. Fifteen composite sediment samples (five samples in each of fifteen different locations) were randomly collected around the Mahakanadarawa tank in April (2022). Twenty surface water samples (Triplicated) were collected from the Mahakanadarawa lake using twenty different locations. Concentrations of metal elements including Mn, Co, As, Cd, Pb, Cu, Zn, Na, K, Al, Ca, Mg, Fe, and Ni were determined using inductively coupled plasma mass spectrometry (ICP-MS) and multi-element standards were used for the instrumental calibration. Statistical analysis was done using SPSS Statistics Software. According to the analysis of the sediment samples, none of the analysed toxic metals have exceeded the severe effect level as well as the lowest effect level. Abundancy of the metals in the sediments samples is varied as Fe> Mn > Cr> Zn > Cu >Pb > Ni >Co> As> Cd. The Igeo (Geo Accumulation value) values obtained, and the index values exhibit that the sediment samples have a tendency to transfer to an unpolluted to moderately polluted stage with analysed toxic metals except for Zn and Cd. Owing to the long-term intense applications of the crop fertilisers and pesticides in the area, toxic metals may be transferred and concentrated in the tanks from the agricultural fields. Apart from that, average concentrations values of analysed metals, including toxic metals such as Pb, As, and Cd in surface water, were far below the irrigation standards. Contamination of food chains and worsening the hazardous conditions for aquatic life can occur due to the toxic metal accumulations in the surface sediments. In order to conduct a health risk assessment for the consumption of tank fish from Mahakanadarawa tank, further studies should be performed by conducting several sampling cycles of sediment and water as well as toxic metal contamination status of inland fish in Mahakanadarawa tank also need to be evaluated.
Investigation of fluoride adsorption capacity of characterized graphene oxide based super sand
(Research Symposium on Pure and Applied Sciences, 2018 Faculty of Science, University of Kelaniya, Sri Lanka, 2018) Perera, R. T.; Pathirannehe, P. N. S.; Weerasooriya, R.; Kumarasinghe, A. R.; Liyanage, J. A.
Sand is conventionally used in water treatment plants to control water turbidity. This research work was aimed for improving its performance using a chemical modification to remove other water contaminants as well. Thus improved substrate was designated as “Super Sand”. Super sand has proven to be a better adsorbent for the removal of fluoride from water. Fluoride is an essential constituent for human health and toxicity of the fluoride depends on the concentration of the fluoride in the drinking water source. The fluoride adsorption capacity of characterized super sand was determined. Graphene Oxide (GO) was synthesized using the modified Hummers method and then GO was coated with purified sand for the generation of super sand. Single GO coated super sand and multiple GO coated super sand were synthesized for the investigation of fluoride adsorption capacity. GO and super sand were characterized using Scanning Electron Microscopy (SEM), Energy Dispersive X-ray Spectrometry (EDXAS), Fourier Transform Infrared Spectroscopy (FTIR) and X-Ray Diffraction (XRD) analysis and surface titration. Surface titration curve depicted that surface charge of super sand vary with pH value of the medium. Between pH 4 to 7 it has a total positive charge and above pH 7 it has a total negative charge. In order to determine the fluoride adsorption process, isotherm studies were done for both single coated and multiple coated super sand. According to the isotherm studies, single coated super sand has the maximum fluoride adsorption capacity at 2 mg/L fluoride concentration and multiple coated one has maximum fluoride adsorption capacity at 3 mg/L fluoride concentration. Further optimization studies were also performed and finally it was proved that fluoride adsorption by the super sand follows the Langmuir isotherm model. Further, FTIR analysis of super sand and fluoride adsorbed super sand at different pH mediums depicted that adsorption process is a chemisorption process. However, FTIR peak patterns depend on the pH of the medium. Hence, it can be concluded that surface modified super sand is suitable for the fluoride removal from the fluoride contaminated drinking water.